Contact us on +39 0322 96142 or

Chipping hammer – compliance pendulous


The chipping hammer CHISEL 4380 is well suited to remove burrs and flashes of mould parting lines particularly in openings, slots and grooves. It is well suited for the deflashing of parts made of gray cast iron- and aluminium-casting. It can be employed in any orientation. The chisel tip is compliable in two directions. The pressure against the part can be set from the robot program.

Datasheet.............Model.............Strokes per minEnergy per blowCompliance in two directions

Compliance torque

@ 6 bar
Compliance force

@ 6 bar
Feed forward rateFluid consumptionChisel mountingWeight
CHISEL 438043801.4 J± 3.8° / ± 17 mm (at chisel)16.6 Nm62 N at chisel5 - 150 mm/s4 l/sSquare shaft 13 mm7.4 kg
The dimensions are indicative and susceptible to changes due to technical improvements. We reserve the right to make changes without notice.